2C soft solder replacement

Name: 2C soft solder replacement
Brand: Würth
SKU: 0892610180

2C-tin-solder replacement
TINSLDRREPL-2C-180ML

Art.-no. 0892610180

EAN 4046777943962

All versions

Specification

High-strength epoxy resin-based 2C bodywork filler compound suitable for cold application as a lead-free alternative to hot soldering with tin.

Alternative to hot soldering

No open flames required

Saves time

No removal of airbags, plastic parts, textiles, tank etc.

No damage to painted surfaces, cavity conservation and joint seals

Good adhesion including on aluminium, iron and steel

Can be painted over

Dust-free sanding

Optimum flexural strength

Resistant to petrol, diesel and diluted acids

Does not shrink

Lead-free

Notice

Suitable for use with any commercially available 310 ml cartridge gun (mechanical/electrical/compressed air) Due to the high viscosity, we recommend the use of cordless or compressed air application guns.

Store unopened in a dry place at 10-35°C. Keep away from direct sunlight.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

Application area

For work on metal surfaces on bodywork, particularly for modelling and touching up repair sites.

Instructions

Thoroughly clean and sand the area to be treated. Remove any old uncured coats of paint and primer. Before use, press on the cartridge until both components are extruded uniformly. Then attach the mixer and discard the first 5 cm of the bead. Now apply the 2-component soft solder replacement and distribute outwards with a spatula starting from the damaged area. Ready to sand with minimal dust after 4-5 hours at 20°C (or approximately 20-30 minutes at 60°C).

Technical information

Contents	180 ml
Weight of content	320 g
Conditions for VOC concentration	ChemVOCFarb
Chemical basis	Epoxy resin
Colour	Silver grey
Hardener content	50 %
Density	1.772 g/cm³
Density conditions	at 20°C
Max. working life	30 min
Min. working life	15 min
Conditions for working life	at 20°C
Conditions for drying time	at 20°C and 50% relative humidity
Min. drying time	4 h
Max. drying time	5 h
Min. processing temperature	10 °C
Max. temperature resistance of the hardened material	100 °C
Max. permissible VOC concentration	250 g/l
Max. VOC concentration	0 g/l
Shelf life from production	12 Month