ABS Lock Wave 100
Anchor point ABS lock f. corrugated-panel roof 100
ANCPT-LOCK-WAVE-100-ZH
Register now and access more than 125,000 products
The ABS-Lock Wave is a stainless steel anchor point with a corrugated aluminium base plate. It fits perfectly into the profiles of corrugated panel roofs (such as the Eternit brand) with wave spacing of 177 mm.
The ABS-Lock Wave anchoring device is made of aluminium and has a stainless steel eyelet, which can be used by up to three people as a stop option. The system is not only tested for the load when falling from the edge of the roof, but also against fall-through in the immediate vicinity of the stop point. On fibre cement roofs, which are often very fragile, the ABS-Lock Wave offers much-needed protection.
The ABS Anti-Lock wave can be used as a single anchor point or as an intermediate or end support in a rope harness system.
DIN EN 795:2012, A + DIN CEN/TS 16415:2013
Datasheets(X)
- For special waveforms, e.g. Eternit roofs and similar
- For load-bearing wooden structures
- Screwed into only one wooden rafter
- Rafters min. 100 x 120 mm
The anchoring device can be installed directly into the rafters with just two screws: A minimum thickness of 100 x 120 mm is sufficient.
Material | Stainless steel |
EN standard | 795 |
Suitable for use in the following materials | Wood, Wood boarding |
Type description | L-WAVE-100-ZH |
Height | 100 mm |
Colour | Stainless steel coloured |
Surface | Stainless steel FINISH |