Adhesive EURABOND RC
Adhesive EURABOND RC
ASMBYADH-EURABOND-RC-600ML
Register now and access more than 125,000 products
May also have anti-intrusion properties
- Adapted to the insulating glass edge seal and laminated glass films
- High strength and elasticity
Easy to apply
- Optimised pot time/curing ratio
- Excellent creep resistance
Good resistance to humidity, weathering and extreme temperatures
Good UV resistance
- Stress cracking: PMMA, ABS, PC and PS must only be glued when they are not under tension, otherwise stress cracks are likely to occur. Preliminary testing is required.
- Avoid contact with substances that react with isocyanate (e.g. alcohol, thinners, cleaners, silane-modified polymer or silicone gap products) before the product is fully cured. These would prevent complete curing.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet!
Datasheets(X)
Bonding of insulating glass units in door and window systems. The adhesive connection improves the quality of the window and can also have anti-intrusion properties.
The application surfaces must be clean, dry and free of grease. The IPA cleaner is best suited to PVC and wooden profiles. The acetone cleaner is only suitable for aluminium profiles. Optimal adhesion is achieved with the EURABOND ACTIVATING CLEANER SILICONE. In the case of PVC profiles, EURABOND PRIMER PVC must then be applied abrasively to the parts to be bonded using the cleaning sponge.
Cut the nozzle tip. Apply the adhesive using a suitable manual, cordless or pneumatic application gun.
For further information, please refer to the technical data sheet.
Contents | 600 ml |
Container | Bag |
Chemical basis | Silicone natural rubber |
Colour | Black |
Density | 1.39 g/ml |
Full curing speed/conditions | 3 mm/d / 23°C and 50% relative humidity, moisture curing |
Shore hardness A/conditions | 40 / in accordance with DIN EN ISO 10563 |
Density/conditions | 1.39 g/ml / in accordance with DIN EN ISO 2811-1 |
Min. tensile strength | 1.2 N/mm² |
Conditions for tensile strength | in accordance with DIN EN ISO 527-1 |
Min. breaking elongation | 180 % |
Min./max. processing temperature | 10 to 35 °C |
Min./max. temperature resistance | -60 to 90 °C |
Max. change in volume | -6 % |
Max. volume change/conditions | -6 % / in accordance with DIN EN ISO 10563 |
Shelf life from production/conditions | 15 Month / at 10°C to 25°C |
Silicone-free | Yes |
Solvent-free | Yes |
Isocyanate-free | No |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!