Assembly fluid For the paint protection film

Name: Assembly fluid For the paint protection film
Brand: Würth
SKU: 0893455

Assembly fluid for paint protection film
ASMBYFLUD-PNTPROTFLM-500ML

Art.-no. 0893455

EAN 4024835854924

All versions

Prices for customers after login

Assembly fluid For the paint protection film

Art.-no. 0893455

Prices for customers after login

Quantity

Exclusively for trade customers

Login/Register
Call customer service:

Specification

For easy installation of WÜRTH paint protection film and other films

Notice

Further processing instructions can be found in the installation instructions of the respective films.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

Instructions

Cut the Würth paintwork protection film to the required size. Intended for license plate lights, key holes, fog lights etc. with corresponding cut-outs. First tape over the cut-out for license plate lighting etc., use a pen to mark the cut-out on the paint film, remove the paintwork protection film and cut out the marked hole with scissors.

Remove the backing paper. Generously moisten the adhesive film side and the paint surface to be glued with Würth assembly fluid (spray bottle). Position the paintwork protection film. The film can be stretched without deforming around curves and corners. Using a blade, spread the assembly fluid in overlapping lines, working from the inside outwards.

However, if there are still air or water bubbles, remove as much of the paintwork protection film as is necessary, spray again with assembly fluid and repeat the process. With any folds, lightly heat up with a hair dryer and smooth the film using a blade.