Assembly paste

Name: Assembly paste
Brand: Würth
SKU: 0893850

Performance solid lubricating Spray can
ASMBYPAST-300ML

Art.-no. 0893850

EAN 4011231894999

All versions

Similar products

Prices for customers after login

Assembly paste

Art.-no. 0893850

Prices for customers after login

Quantity

Exclusively for trade customers

Login/Register
Call customer service:

High-performance assembly paste spray for run-in lubrication

Protects against wear and ensures run-flat properties

Solid sliding film reduces friction, prevents overheating and seizing.

High resistance

Resistant to water, salt water, thinned acids and alkaline solutions

The solids content of 60% is resistant to petrol, diesel, etc.

Temperature and pressure resistant

Temperature-resistant from -35° C to +150° C, higher temperatures possible for short periods in the event of reduced air access

Pressure-resistant up to the yield point of all known metals

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue

Datasheets(X)

Safety data sheet

Certificates/ Documents

Application area

Can be used as wear-in lubricant for new machines, guides, threaded spindles, spline shafts, heavily loaded gear transmissions, worm gears and manual transmissions as well as chemical devices, slide bearings with high thermal and surface load; force fits of all kinds for fitting and press-fitting roller bearings, washers, wheels, flanges and bolts; fittings (sliders, valves, taps). For deep drawing, thread cutting, drilling and sawing. For cutting, punching and bending tools.

Instructions

Shake the product before use. Spray onto the surface to be treated and steam off the solvent.

Chemical basis	Calcium complex grease
Colour	Black
Smell/fragrance	Characteristic
Density	0.75 g/cm³
Density conditions	at 20°C
Min. temperature conditions	-30 °C
Max. temperature conditions	150 °C
Max. short-term temperature resistance	1100 °C
Min. flashing point	-80 °C
AOX-free	Yes
Water-soluble	No
Resistance against	Lye Salt water Acid Water
VOC concentration (CH)	80.78 %
Contents	300 ml
Container	Aerosol can
Shelf life from production	24 Month

Suitable glove:

Product

Description

Nitrile chemical protective glove With cotton velour finish inside

Description:

Permeation level: 6

Nitrile chemical protective glove Long, heavy-duty design

Description:

Permeation level: 6

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time

Permeation level

< 10 min

≥ 10 min

≥ 30 min

≥ 60 min

≥ 120 min

≥ 240 min

≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.