BS-V fire protection connector for use in system G3.1
Fire protection connector SML
CON-PIPSLEV-SML-PLA-DN100
Art.-no. 0893304104
EAN 4099618689666
Register now and access more than 125,000 products
Stainless-steel pipe connectors with fire protection properties for use in cast pipe systems in accordance with DIN 19522/EN 877
- In the event of a fire, the intumescent material has a foaming effect, which closes the main pipe
- End-to-end EPDM seal
- Protection against mechanical influences
- Can also be mounted in branch sections
The general fastening guidelines from the pipe manufacturers must also be observed during installation.
Datasheets(X)
The BS-V fire protection connector for use in system G3.1 serves as pipe insulation for floor-to-floor sealing of cast-iron pipes (also mixed installation) in house drainage systems.
- Installation on a straight pipe: cast iron pipe DN50 to DN150 (variant 1: Z-19.53-2711)
- Installation on a branch section: up to DN100 (variant 2: Z-19.53-2712)
- Plastic pipes to be connected, without restriction/manufacturer's reference
- Install the BS-V fire protection connector in the cast pipe branch like a "normal" connector
- 1. Install the fire protection connector up to the stop collar of the seal on the end of the pipe that has been cut at a right angle
- 2. Push the end of the pipe or fitting into the connection until it stops
- 3. Tighten the hexagon screws alternately using a socket wrench, hand ratchet or cordless screwdriver until the two clamping heads collide; proceed with block mounting. Torque 10-20 Nm
Once the heads collide, do not tighten them further. - 4. Installing the BS ceiling strip: Place the ceiling strip above the ceiling and around the cast pipes and connectors, ensuring that there is a ≥ 20 mm overhang. Fasten using aluminium adhesive tape. Additional insulation above the ceiling
- 5. Seal the remaining gap with fire protection cement
DN nominal width | DN 100 |
Suitable for pipe (HT) | DN 100 |
Suitable for pipe (SML) | DN 100 |
Outer diameter of SML pipe | 110 mm |
Outer diameter of plastic pipe min. | 110 mm |
Outer diameter of plastic pipe max. | 110 mm |
Outer diameter | 130 mm |
Height | 120 mm |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Low-cut safety shoes, S2 Uvex 1 G2 6844
Cutting disc Speed for steel
HSCo8 AlCrN annular cutter
ORSY®BULL series 5/7 castor
Work dungarees Kübler Vita Mix 3L47 5365
2-way blow-out gun with a control button for the infinitely variable adjustment of air flow
Tool head, small design For crimping pliers
Scorpius winter softshell jacket
Flat washer without chamfer ISO 7089 steel 200 HV, zinc flake silver (ZFSH)
Work overall Planam Tristep rallye overalls