Bolt M6 BFS 6 For steel substructures
Stud M6 for steel BFS 6
STUD-ST-BFS6-LT12-LS12-M6
Register now and access more than 125,000 products
Practical tip:
- To prevent the connection between the bolt and the mounting substrate being overloaded by torsion forces, the corresponding female thread must be screwed tightly using a torque wrench
- Recommended tightening torques: M6/M8
- Concrete surfaces: 4 Nm/6 Nm
- Steel surfaces: 6 Nm/8 Nm
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
Shaft length (Ls) | 14 mm |
Shank diameter (ds) | 3.7 mm |
Head diameter ( dk) | 8 mm |
Thread length (metric thread) (Lg) | 10 mm |
Thread type x nominal diameter | M6 |
Suitable for device type | Würth BST 350, Hilti DX 2, Hilti DX A40, Hilti DX A41, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Forestry protection glove
Label carrying system for identification rings
Self-adhesive label
Charger for Easy Puller dent repair system
Hexagon shoulder screw with long threaded pin DIN 609, steel 8.8, zinc-plated, blue passivated (A2K)
Hexagonal bolt with flange in accordance with MBN standard
Colour – blind rivets Round pan head
Work dungarees
Slotted countersunk head screw DIN 963, 4.8 steel, plain
Replacement foot For aluminium ladders