Bond and Seal All-in-One structural adhesive

Sprayable and brushable

• One product for two applications


• Broad range of OEM structures can be readily reproduced

Solvent-free

• No material shrinkage after drying


• Satisfies the latest environmental protection requirements

Permanently elastic once hardened

• Minimises the formation of cracks in the paint, which can be caused by vibrations or compressive loads


• Excellent stone chip protection


• Resistant to mechanical damage

Can be painted over up to five days later

• Can be painted over both before skin formation (wet-in-wet) and also up to five days later with all commercially available paints


• Ideally suited for painting over with water-based paints

UV-resistant

Very good ageing behaviour, even at unpainted seams

Very broad adhesive range

• Adheres to most surfaces without priming


• Permanent connections

Isocyanate-free, PVC-free and silicone-free

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.