CERAfix 300 1C sealing compound
SEALCOAT-1C-(CERAFIX300)-15KG-GREY
Register now and access more than 125,000 products
- Quick setting and suitable for laying tiles and panels approx. 3-4 hours after applying the second coat
- Easy to spread and smooth
- Easy to apply
- Can be applied using a suitable brush, trowel or spraying device
- Water vapour permeable and resistant to frost, UV and ageing
- Suitable for compound sealing in water impact classes W0-I to W3-I without chemical exposure in accordance with DIN 18534 Part 3
This product is classified in accordance with EMICODE® (EC1 Plus). EMICODE® is an independent labelling system for low-emission products, based on specified test methods and limit values.
- Direct contact with metals such as copper, zinc and aluminium must be prevented by using a pore-tight primer such as CERAfix 103 2C special adhesive primer/CERAfix 203 casting and adhesive resin.
- The substrate and CERAfix 300 must be prevented from dropping below the dew point (condensation formation) during the application and drying phases.
- In rooms with a low temperature, high humidity and insufficient ventilation, an extended drying time should be anticipated. Direct heaters are not suitable for drying in these types of rooms!
- Protect surfaces that do not require treatment against exposure to CERAfix 300!
- During the bonding process, the seal must not be exposed to water. If water gets behind the material, it can lead to spalling in the event of frost.
- Avoid exposure to direct sunlight during application.
- During the drying phase, the seal must be protected from water.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
The single-component flexible sealing slurries are used for sealing under tiles in applications where long-term and permanent protection against water exposure must be ensured, e.g. in residential bathrooms and kitchens, private and public toilet facilities and pool surrounds. The product is suitable as a seal in a composite for water impact classes W0-I to W3-I without chemical impact in accordance with DIN 18534 and ZDB information sheet "Compound sealing".
Prime the surface with CERAfix 101 (avoid puddling!) or moisten it so that it is matt moist when the CERAfix 301 slurry-type seal coating is applied. As an alternative to CERAfix 101, CERAfix 102 can be used with a mixing ratio of 1:3 to water.
Chemical basis | Cement, mineral and polymer modified additives |
Min. processing temperature | 5 °C |
Max. processing temperature | 30 °C |
Min./max. processing temperature | 5 to 30 °C |
May be walked on after max. | 4 h |
Covering conditions | at 23°C and 50% relative humidity |
Can be covered after (wall) | 4 h |
Application quantity in weight/area | 1.25 kg/m² |
Application quantity per coating thickness | 1.25 kg/mm/m² |
Min. coating thickness | 2 mm |
Max. coating thickness | 5 mm |
Processing time | 45 min |
Conditions for processing time | at 23°C |
Viscosity/consistency | Powder |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Round-headed strip nails, 34° with ring shank. Plain A2 stainless steel
Longlife & Speed HSSCo8 bimetal cylinder saw
Post upper part for pitched roof edge protection systems
Square solid spindle 8 mm
Emsland sand shovel
Drill gauge For 3D hinges with 2 bolts, 16 mm
4KS profile thumbturn cylinder for keyed-alike original systems
Wedge lock washer W.TEC, narrow shape
Special PP packing tape
PVC rivet