Combination locking claw
Combination locking claw
LOKCLW-(SML-CV-RAPID-CON)-DN100
Register now and access more than 125,000 products
- For single and two-screw connectors
- For interior pressure loads up to 10 bar for DN 50 – DN 100 (DN 125 – 150 5 bar, DN 200 3 bar)
- Suitable for all Rapid (except DN 250) connectors and all CV + CE two-screw connectors
- DN 250 for CV connectors only
For article numbers 0544007200 and 0544007250 the design features three claw sections
Datasheets(X)
- Rain and dirty water lines in backup areas
- Roof draining piping (HDE system)
- Lifting systems
- Loosely screw both claw halves onto pipe
- Make sure that claw halves do not sit on the clamp strap of the connector
- Tighten the screws diagonally to ensure even seating of the locking claw
- Observe tightening torques (check with torque wrench)
 | |
DN nominal width | DN 100 |
Material designation | S235JR |
Operating pressure | 10 bar |
DIN | 912 |
Diameter (D) | 184 mm |
Min./max. torque | 23-28 Nm |
Min. torque | 23 Nm |
Nominal diameter | 10 mm |
Nominal diameter x screw length | 10 x 35 mm |
Screw length | 35 mm |
Property class | 8.8 |
Thread type | Metric thread |
Length (L) | 87 mm |
Max. torque | 28 Nm |
EN standard | 10025 |
Last viewed
Plastic expanding rivet without cap, with grooves
Rivet nut with flat head and knurled shank
Hookit sanding disc 255P
Countersunk tapping screw shape C with H recessed head DIN 7982, A4 stainless steel, plain
Steel U-bolt DIN 3570, A4 stainless steel, plain
AL 440 TBT window handle
Cylindrical roller bearing FAG
Protective glove, chemicals
Hexagonal bolt with shank ISO 4014, steel 10.9, plain
Spiral clamping pin, standard design ISO 8750 A2 stainless steel plain