Combination locking claw
Combination locking claw
LOKCLW-(SML-CV-RAPID-CON)-DN125
Register now and access more than 125,000 products
- For single and two-screw connectors
- For interior pressure loads up to 10 bar for DN 50 – DN 100 (DN 125 – 150 5 bar, DN 200 3 bar)
- Suitable for all Rapid (except DN 250) connectors and all CV + CE two-screw connectors
- DN 250 for CV connectors only
For article numbers 0544007200 and 0544007250 the design features three claw sections
Datasheets(X)
- Rain and dirty water lines in backup areas
- Roof draining piping (HDE system)
- Lifting systems
- Loosely screw both claw halves onto pipe
- Make sure that claw halves do not sit on the clamp strap of the connector
- Tighten the screws diagonally to ensure even seating of the locking claw
- Observe tightening torques (check with torque wrench)
 | |
DN nominal width | DN 125 |
Material designation | S235JR |
Operating pressure | 5 bar |
DIN | 912 |
Diameter (D) | 201 mm |
Min./max. torque | 25-30 Nm |
Min. torque | 25 Nm |
Nominal diameter | 10 mm |
Nominal diameter x screw length | 10 x 35 mm |
Screw length | 35 mm |
Property class | 8.8 |
Thread type | Metric thread |
Length (L) | 98 mm |
Max. torque | 30 Nm |
EN standard | 10025 |
Last viewed
Twist drill bit HSCo DIN 338 type RN oxide
Hose with couplings Sundström R03-2505
Adjustable T-shaped sealing cone fitting ISO 8434-1, zinc-nickel-plated steel, cutting ring connection with o-ring
Cylindrical pin, unhardened with oval points DIN 7, plain steel (9 SMnPb 28 k or St 50 K), unhardened, tolerance class m6
Feather key, high profile DIN 6885, steel C 45 K, plain, shape A
Euro containers
3/8 inch cardan joint
Removal adapter set R134a For 12 kg R134a reusable refrigerant bottles
Roller shutter system vertical installation box For top-mounted cabinets and wall cabinets
Safety boots, S3