Combination locking claw
Combination locking claw
LOKCLW-(SML-CV-RAPID-CON)-DN80
Register now and access more than 125,000 products
- For single and two-screw connectors
- For interior pressure loads up to 10 bar for DN 50 – DN 100 (DN 125 – 150 5 bar, DN 200 3 bar)
- Suitable for all Rapid (except DN 250) connectors and all CV + CE two-screw connectors
- DN 250 for CV connectors only
For article numbers 0544007200 and 0544007250 the design features three claw sections
Datasheets(X)
- Rain and dirty water lines in backup areas
- Roof draining piping (HDE system)
- Lifting systems
- Loosely screw both claw halves onto pipe
- Make sure that claw halves do not sit on the clamp strap of the connector
- Tighten the screws diagonally to ensure even seating of the locking claw
- Observe tightening torques (check with torque wrench)
 | |
DN nominal width | DN 80 |
Material designation | S235JR |
Operating pressure | 10 bar |
DIN | 912 |
Diameter (D) | 149 mm |
Min./max. torque | 17-23 Nm |
Min. torque | 17 Nm |
Nominal diameter | 8 mm |
Nominal diameter x screw length | 8 x 30 mm |
Screw length | 30 mm |
Property class | 8.8 |
Thread type | Metric thread |
Length (L) | 72 mm |
Max. torque | 23 Nm |
EN standard | 10025 |
Last viewed
Circlips for shaft, shape A
AW® C 6.3 bit (1/4 inch) with patented AW tip and colour coding
Work trousers
GEFU® thread-rolling screw With Taptite 2000® thread, flattened half round head with collar and hexalobular drive
Adjustable L-shaped sealing cone fitting ISO 8434-1, zinc-nickel-plated steel, cutting ring connection with o-ring
Hexagon nut, low profile DIN 985, steel I6I/I8I, zinc-plated, blue passivated (A2K)
Filling station connector with handle
Pegboard for RW system wheeled workbench
Grip plug GPN 315 Polyethylene (PE-LLD), yellow
Cable and pipe spacer clip with longitudinal hole