Cross-hole countersink Ruko conical countersink with cross hole 90° HSS TiN
Cross-hole countersink HSS TiN 90° Ruko
CNTSNKCONE-RUKO102304T-90GRD-D15,0-20,0
Register now and access more than 125,000 products
The chip flow through the hole prevents the chips from binding in the workpiece.
Ideal for burr- and chatter-free deburring and countersinking of steel, cast iron, non-ferrous and light metals. Optimal results at a low cutting speed.
Countersink with blade is not recommended for full countersinking.
Datasheets(X)
Min./max. spot-facer diameter | 20-15 mm |
Head diameter | 28 mm |
Length | 85 mm |
Shank diameter | 12 mm |
Material | HSS |
Countersink angle | 90 Degree |
Last viewed
Hexagon nut, low profile, with clamping piece (non-metal insert) DIN 985, A2 stainless steel, plain
Hand tap, taper tap HSS DIN 2181
Anti-roll-off edging For cabinet covers of system cabinets
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated thick-film passivated (ZSML)
Cetus trousers with holster pockets
Camshaft setting bar
Threaded pin ISO 4027, steel, 45H, plain
PUR 250 type 175 insulation pipe clamp With screws, a permanent PUR hard foam coating and rubber shell on the inside
Box-end wrench with square insert shank 14x18 mm
Concrete screw with hexagon head W-BS/S