Cross-hole countersink assortment Ruko 102312TRO conical and countersink deburring tool set with cross hole 90° HSS TiN, 4 pieces
Cross-hole counters. set HSS TiN 4pcs Ruko
CNTSNKCONE-RUKO102312TRO-90GRD-2,0-20,0
Register now and access more than 125,000 products
The chip flow through the hole prevents the chips from binding in the workpiece.
Ideal for burr- and chatter-free deburring and countersinking of steel, cast iron, non-ferrous and light metals. Optimal results at a low cutting speed.
Countersink with blade is not recommended for full countersinking.
Datasheets(X)
Material | HSS |
Number of pieces in assortment/set | 4 PCS |
Last viewed
Over dead centre tensioner With belt and A2 flat hook
Heat protection ring
Wooden shaft, conical With ground cone and rounded shaft end
Hole puncher with splitting punch Metric ISO sizes in accordance with EN 50262
Cut protection glove Ejendals TEGERA® 433
Threaded fitting
Interior trim clip, type S
Tapered pin, unhardened DIN 1, plain steel, unhardened, design A (ground)
Cable clamp type H
Countersunk head screw with recessed head, H DIN 965, steel 4.8, zinc-plated, blue passivated (A2K)