Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ3-(M7-M9)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 25 x 9 mm |
Datasheets(X)
Last viewed
Article sticker
Knob cylinder 3KS
Heavy Duty floor marking, L-piece
Work trousers
VARIFIX® hammer head fastener standard fix Pre-assembled with nut and washer, zinc-plated
Pavers' hammer, round
End mill, long, triple blade, centre cutting
Solid carbide end mill, long, triple blade
Hexagonal bolt with shank ISO 4014, steel 10.9, zinc flake, silver (ZFSHL)
EPS profile thumbturn cylinder
