Dowel pins
Rod anchor
RODPLG--(A2K)-10X180MM
Register now and access more than 125,000 products
- Chamfered for easier driving-in
- Material: steel S235
- Surface: blue passivated (A2K); ≥ 7 μm
- Application in utilisation classes 1 and 2
Install dowel pin flush with the timber surface. The hole in the wood must be no larger than the bar dowel diameter.
The inner sheet steel element in sheet steel to wood connections should be at least 3 mm thick as the minimum edge distances are determined exclusively from the edge distances in the wooden component from this thickness upwards.
Available work documents:
Load tables and detailed processing instructions can be found on the service page www.wuerth.de/holzverbinder.
CE marking in line with EN 14592
Datasheets(X)
Fastening inner steel to wood or wood to wood connections of e.g. post support brackets, join connections, tie rod connections or joist brackets.
The diameter of bore holes in the wood must correspond to the dowel pin diameter.
The diameter of bore holes in the metal may only be max. 1 mm larger (nominal external diameter) than the dowel pin diameter.
Diameter (Ø) | 10 mm |
Length (L) | 180 mm |
Material | Steel |
Material designation | S235 |
Surface | Zinc plated |
Yield moment | 56.1 Nm |
Last viewed
Hexagonal bolt with shank SB FITTINGS DIN EN 15048-1
Hole saw Ruko tungsten carbide multigrade hole saw
Hexagonal bolt with thread up to the head DIN 933, brass, plain
Hexagonal bolt with shank
Flat washer without chamfer
Safety boots, S3
Work jacket
Plaster strips, detectable Blue, containing metal
Castellated nut, low profile with fine thread DIN 937, steel, 17H/22H, plain
Spirit level made of light metal