Dowel pins
Rod anchor
RODPLG-(A2K)-16X210MM
Register now and access more than 125,000 products
- Chamfered for easier driving-in
- Material: steel S235
- Surface: blue passivated (A2K); ≥ 7 μm
- Application in utilisation classes 1 and 2
Install dowel pin flush with the timber surface. The hole in the wood must be no larger than the bar dowel diameter.
The inner sheet steel element in sheet steel to wood connections should be at least 3 mm thick as the minimum edge distances are determined exclusively from the edge distances in the wooden component from this thickness upwards.
Available work documents:
Load tables and detailed processing instructions can be found on the service page www.wuerth.de/holzverbinder.
CE marking in line with EN 14592
Datasheets(X)
Fastening inner steel to wood or wood to wood connections of e.g. post support brackets, join connections, tie rod connections or joist brackets.
The diameter of bore holes in the wood must correspond to the dowel pin diameter.
The diameter of bore holes in the metal may only be max. 1 mm larger (nominal external diameter) than the dowel pin diameter.
Diameter (Ø) | 16 mm |
Length (L) | 210 mm |
Material | Steel |
Material designation | S235 |
Surface | Zinc plated |
Yield moment | 170.2 Nm |
Last viewed
Round head screw with square neck and nut DIN 603, steel 4.8, plain, with nut
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 10.9, plain
Cylindrical pin, unhardened ISO 2338 A1 stainless steel (m6)
Conical washer, shape D
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain
Reserve taper grooved dowel pin ISO 8741 steel plain
piasta® wing-type drilling screw, countersunk milling head with AW drive
GEFU® thread-rolling screw With Taptite 2000® thread, countersunk head and hexalobular drive
Flat washer without chamfer ISO 7089 steel 200 HV, zinc-plated, blue passivated (A2K)
ASSY® 4 CSMP ZiNi timber screw Steel zinc-nickel partial thread countersunk milling pocket head