Drainage and protective membrane for structural sealing
Protection and drainage mat
NOTCHPROTBRD-THREE-COAT-2,0X15M
Register now and access more than 125,000 products
- Components: Dimpled membrane (HD-PE), woven filter (PP), sliding film (LD-PE)
- Average compressive strength
- Drains off collecting water and leakage water dependably
- Rot-proof
- Root- and impact-resistant
- Shape-holding
- Resistant to aggressive waters
- Drinking water safe
Datasheets(X)
The drainage and protective membrane is laid loosely over finished waterproofing surfaces. The black sliding film faces the structure and the protective fleece is turned against the soil. At joints the membrane is to be overlapped by at least 10 cm. The fleece side is laid over the overlapping membrane. At edges, the membrane is to be guided approx. 15 cm further than the sealing surface and sealed against dirt ingress. The membrane can also be attached at these points. The slope must be at least 2% when laid horizontally. Contact with sharp-edged objects must be avoided.
Length | 15 m |
Area | 37.5 m² |
Width | 2.0 m |
Height of dimples | 8 mm |
Min./max. temperature resistance | -30 to 80 °C |
Max. pressing pressure | 250 kN/m² |
Coating weight per m² | 800 g |
Water drainage capacity per m | 3.5 l/s |
Number of plies | 3 PCS |
Last viewed
Nylon anchor For light loads (secondary attachments)
Rubber module, large
Mounting frame set 4 for workbenches
HSCo Multi Performance machine tap for blind holes DIN 371/376
SC long twist drill bit DIN 338
ABS spiral wire 5-pin 24V For brake systems
Countersunk head screw with recessed head, H DIN 965, steel 4.8, zinc-plated, blue passivated (A2K)
Fleece wrapping tape
Pneumatic cleaning gun TOP Gun
Collated nails and gas cartridge NG CS-2/3