EPDM sealing corner
Corner seal EPDM
SEALEDG-EPDM-252X51X27X1MM
Register now and access more than 125,000 products
- Forming a second water-bearing level in conjunction with insulating wedge, EPDM sealing tape and reveal plate
- Any water coming from the component joint or accumulating in the area of the interface gap is safely drained to the outside
- The EPDM sealing corner can be cut open to the left or right due to its closed geometry, allowing for flexible application on the right or left side
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
For creating a lower window ledge in area of the outer window sill. In conjunction with EPDM sealing tape and an insulating wedge, a second water-bearing level is achieved under the window sill. Applied especially when using a window sill system without proof of sealing.
Installation:
The EPDM sealing corner is inserted into the joint up to the back edge of the multifunctional tape or VKP tape. The sealing corner is cut open from the outer edge of the window frame. When using an insulating wedge, the cut is made in the sloped part of the wedge.
It is important that the sealing corner leads to the drip edge and that this is maintained when cutting to length.
The EPDM sealing corner is glued down into the joint with EPDM sealing tape adhesive/SMP EPDM sealing tape glue. For better adhesion, it is recommended to roughen the sealing corner where it is to be glued with abrasive paper. The EPDM sealing tape is then placed over the EPDM sealing corner and glued in place with EPDM sealing tape adhesive/SMP EPDM sealing tape glue.
Material | EPDM (ethylene propylene diene monomer rubber) |
Length | 252 mm |
Width | 51 mm |
Height | 27 mm |
Thickness | 1 mm |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Face wrench, depressed centre For angle grinders with M14 spindle thread
O-ring, metric
Lock washer
Hole puncher with splitting punch Metric ISO sizes in accordance with EN 50262
Divider assortment Divider assortment with compartment rails and compartment dividers for system dimensions 8.8
Work coat
Threaded fitting DIN 976-1 (shape A) with standard metric ISO thread, zinc-plated steel 4.8, blue passivated
Spacer washer
Work jacket Peter fleece jacket
Universal switch cabinet key 9 in 1