End brush Steel, crimped, with shank
Tapered brush steel with shank
CENTFBRSH-12X0,3-S6
Register now and access more than 125,000 products
- Increased stability during brushing
- Crimped wire bristles support each other
- For use on die grinders and drills
- High speeds improve brush performance and service life, especially in the case of straight grinders and manual grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
- Cleaning corners, recesses, holes
- For cleaning moulds/cast parts
- For removing paint and rubber residues
 | |
Diameter (D1) | 12 mm |
Sleeve diameter (D2) | 10 mm |
Usable length of wire (H) | 20 mm |
Wire diameter | 0.30 mm |
Length (L) | 60 mm |
Shank diameter (S) | 6 mm |
Material of wire | Steel |
Design | Corrugated, with shank |
Aggressiveness | Middle |
Suitable for cordless drills (points system) | 2 of 4 points |
Suitable for drill (points system) | 2 of 4 points |
Suitable for straight grinder (point system) | 4 of 4 points |
Max. rotation speed | 20000 rpm |
EN standard | 1083-2 |
Last viewed
Polyamide/cotton coarse-knit glove
Inductive charging station 24 V For wireless charging of devices with induction batteries, as well as additional USB charger
Slotted countersunk head screw ISO 2009, steel 4.8, zinc-plated, blue passivated (A2K)
Taper-grooved dowel pin DIN 1472, A1 stainless steel, plain
Dry sandpaper strips
Profile half cylinder EPS
Hexagonal bolt with shank
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
Concealed drawer front for Vionaro frame system
Sheet metal nut with threaded shank