End brush Steel, knotted, with shank
Spindle-mounted wheel brush/wire end brush, steel
CENTFBRSH-PWRDRL-19X0,3-S6
Register now and access more than 125,000 products
- Aggressive effect thanks to knotted wire
- The knots open more or less depending on the speed, and high speeds improve the brushing performance and service life
- For use on die grinders and drills
- Only the bristle tips act on the workpiece. Excessive contact pressure does not improve the result, but increases the required drive power and reduces the service life of the brush.
- In order to control the spread of the brush, use tool drives with adjustable speed.
- For the best performance, use a tool drive with at least 500 W.
- Always wear safety goggles and protective gloves when working with machine brushes!
- Cleaning corners, recesses, holes
- For cleaning moulds/cast parts
- For removing paint and rubber residues
 | |
Diameter (D1) | 20 mm |
Sleeve diameter (D2) | 19 mm |
Usable length of wire (H) | 28 mm |
Wire diameter | 0.35 mm |
Length (L) | 72 mm |
Number of braids | 6 PCS |
Shank diameter (S) | 6 mm |
Material of wire | Steel |
Design | Braided |
Aggressiveness | Middle |
Suitable for cordless drills (points system) | 2 of 4 points |
Suitable for drill (points system) | 2 of 4 points |
Suitable for straight grinder (point system) | 4 of 4 points |
Max. rotation speed | 20000 rpm |
EN standard | 1083-2 |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
Work vest
AS S3 safety shoe
C 6.3 PH bit (1/4 inch)
Work dungarees
Washer DIN 1440, A2 stainless steel, plain, for bolt
Identification rings, PVC
TX bit C 6.3 (1/4 inch) with hole
GEFU® thread-rolling screw With Taptite 2000® thread, flat head and hexalobular drive
Low-cut safety shoes, S2
Tile grout float
