Welcome to Würth Aerospace Solutions For trade customers only

Filler Light filler

Filler, light filler
FILR-GAP/JOINTFILLER-WHITE-310ML

Art.-no. 0892162310
EAN 4052703415526

Prices for customers after login
Filler Light filler

Art.-no. 0892162310

Prices for customers after login
Quantity
PU

Exclusively for trade customers

Register now and access more than 125,000 products

Light filler for filling joints, cracks and holes in wall and ceiling surfaces
  • Ready-to-use for fast application

  • Almost no shrinkage, which eliminates cracking

  • Easy to paint over with emulsion paints

  • Easy to sand with 200 μm grain content max. 1 %
Notice

Please note that these values merely serve as empirical values. It should therefore be noted that the hardening time increases with thicker joints. The spatula, type 4A, can also be processed according to EN 13963 without joint cover strip. Cleaning: With water

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Datasheets(X)

Safety data sheet

Certificates/ Documents

 | 

 | 

Application area

The light filler is suitable for filling joints, cracks and holes in walls and ceilings (e.g. gypsum plasterboard, acoustic panels). Small uneven areas in surfaces on walls can also be compensated, such as those that become visible when scraping off wallpaper. Can also be used in model construction.

Instructions

The base material must be clean, dry and free from dust and grease. Using a cartridge or spatula, apply and spread the light filler to the joint, crack or hole. With joints, the protruding joint compound can be cut away with a utility knife after approx. 15-20 minutes. For more information, please refer to the technical data sheet.

Chemical basis

Acrylate dispersion

Density

0.57 g/cm³

Viscosity/consistency

Pasty

Min./max. processing temperature

5 to 30 °C

Min./max. curing time

6-8 h

Grain size

200 µm

Colour

White

Contents

310 ml

Container

Cartridge

Shelf life from production

12 Month

Conditions to maintain shelf life from production

at 5°C to 25°C

Max. temperature resistance of the hardened material

-15 °C

Min. curing time

6 h

Max. curing time

8 h

Curing time conditions

depending on layer thickness

Recoatable/Can be painted over

Yes, after 15-20 minutes

Additional articles

Cartridge gun, art. prefix no. 0891...

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents

 | 

 | 

Technical information