Fire protection duct outer corner I30/I60/I90/I120
Fire protection outer corner I30/I60/I90/I120
EXCRN-FP-F.FPDCT-I-30X30MM
Register now and access more than 125,000 products
- No propagation of fire in the duct; actively inhibits fire
- Low space requirements as virtually the entire duct cross-section is usable
- Fast, simple installation; easily mountable, self-closing components
- Dust-free installation
- Simple fastening, even directly on ceilings or walls
- Easily accessible, therefore maintenance-friendly; easy and simple to add to installation at a later stage
- Cable versions available with metal or plastic cable fittings in accordance with EN 60 423
- Dimensionally stable
- Special shapes also deliverable via special order: Two-sided, three-sided, four-sided, round duct, stainless steel duct, surfaces in RAL colours
- Interior coating begins to react at +200°C
- Low tare weight
- Where cables and pipes are placed directly on the element, the permissible total weight resulting from cable and pipe weight ≤ 34 kg/m.
- Store dry and frost-free
- General technical approval Z-19.30-2214
- Fire resistance duration I 30 to I 120
For use in system E4
Fire protection duct I 30/I 60/I 90/I 120 for encapsulation of combustibles
- Escape and rescue routes, as well as in essential corridors and stairwells
- Suitable for cables, flammable pipes and non-flammable pipes with flammable synthetic rubber insulation
- The I-duct can be routed through fire-resistant solid and lightweight partition walls
- Duct itself can act as a cable conduit
The installation instructions and general type approval Z-19.30-2214 must be strictly observed when installing the fire protection duct.
Width x height | 30 x 30 mm |
Fire resistance rating | I30, I60, I90, I120 |
Angle | 90 Degree |
Surface | Zinc plated |
Colour | White |
Material | Steel / steel |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
PLUS rail connector for PLUS mounting rail
Abrasive/sticker wheel Mirka Coarse Cut
Ducting clamp Part 3 – Double series
Plumber's sealing screw, A2 stainless steel
Twist drill bit HSCo DIN 338 MFD Speed
Slotted flat-head screw DIN 85, brass, plain
Corrugated pipe PA12-MOD/BS
Machinist's hammer German design in accordance with DIN 1041
Conical countersink HSS Ruko plain bit 90° "Short"
WÜPOFAST® zinc-plated blue chipboard screw
