Heavy-duty anchor W-TM type O with eyelet

Name: Heavy-duty anchor W-TM type O with eyelet
Brand: Würth
SKU: 0904901867

Heavy-duty anchor W-TM type O steel zinc plated
ANC-(W-TM/S-O)-(A2K)-M10X60

Art.-no. 0904901867

EAN 4045989060788

All versions

Prices for customers after login

Heavy-duty anchor W-TM type O with eyelet

Art.-no. 0904901867

Prices for customers after login

Quantity

x 25 pcs

Exclusively for trade customers

Specification

For uncracked concrete, zinc-plated steel

Applying the specified torque during the anchoring process ensures secure installation

Load-controlled/torque-controlled expanding galvanised steel anchor in sizes M6–M12

Create the drill hole

Clean the drill hole

Knock in anchor until flush

Mount component

Apply torque

Application area

Suitable for fastening: Transfer lines on the ground requiring installation flush with the surface; steel structures, metal profiles, brackets, base plates, cable conduits, piping, mounting rails etc.

Can be used in concrete
The anchor may be used for anchorages with predominantly static loads or quasi-static loads


Anchor diameter	10 mm
Anchor length (l)	60 mm
Nominal drill-bit diameter (d 0)	14 mm
Drill hole depth (h 1)	70 mm
Effective anchoring depth (h ef)	51.5 mm
Material	Steel
Surface	Zinc plated
Torque during anchoring (T inst)	20 Nm
Through-hole in the component to be connected (d f)	12 mm

Performance data
Anchor diameter [mm]			M6	M8	M10	M12
Recommended load of an individual anchor without influence of the edge distance type O	Compressive zone (uncracked concrete C20/25²⁾), s ≥ 3 h_ef, c ≥ 1.5 h_ef	N_rec [kN] = C20/25²⁾	1,4	2,4	3,6	6,0
¹⁾ The partial safety factors of the resistances regulated in the approval and a partial safety factor of the actions of Y_F = 1.4 have been taken into account. Please refer to the European Technical Approval Guidelines (ETAG), Appendix C, for information on combining tensile and transverse loads, edge influence and groups of anchors. ²⁾The concrete has normal reinforcement. Higher values are possible for higher concrete compressive strengths. ³⁾ Compliant with approval if screws and threaded rods with acceptance test certificate 3.1 in accordance with EN 10204:2004 are proven to be the required material and to possess the mechanical properties stipulated in ETA-10/0255. ⁴⁾ Type S: If a lower fixture thickness is required, make a deeper drill hole accordingly.