Hex head screw with thread up to head DIN 933, steel 8.8U, hot-dip galvanised (hdg)
DIN 933 hot-dip galvanised steel 8.8U
SCR-HEX-DIN933-8.8U-WS60-(HDG)-M39X140
Register now and access more than 125,000 products
- Manufactured with undersized thread in tolerance class 6AZ (thread play) before surface protection is applied (DIN EN ISO 10684).
- The screws are ISO-compliant after hot-dip galvanisation.
- The screws must not be used with nuts that have an oversized thread. This can create problems in the screwed joint and may cause the connection to fail.
DIN 933 has been withdrawn and replaced by ISO 4017. There is some similarity (nominal dimensions extended | width across flats changed for M10, M12, M14 and M22).
Datasheets(X)
 | |
Thread type x nominal diameter (d1) | M39 |
Length (l1) | 140 mm |
Head height (k1) | 25 mm |
External drive (s1) | WS60 |
Standards | DIN 933 |
Material | Steel |
Property class | 8.8U |
Surface | Hot dip galvanized |
Head type | Hexagon head |
Drive type | Outer hexagon |
Thread type | Metric thread |
Thread form | Standard metric thread |
Thread design | Full thread |
Thread length (metric thread) | 140 mm |
Product class | B |
RoHS-compliant | Yes |
Last viewed
Hexalobular-type cheese head screw, low head
Hexagon head bolt with shank for pressure container construction (PED) ISO 4014, steel 25CrMo4, plain
3/4 inch grooved nut wrench basic body For removal and installation work on the rear axle
Centring sleeve for wheel bearing
Safety boots, S3
Adjustable L-shaped sealing cone fitting ISO 8434-1, stainless steel 1.4571, cutting ring connection with o-ring
Work jacket
T-piece, reduced with solder connection EN1254, copper, 5130R
Adhesive lubricant HHS® 1000
Low-cut safety shoe S2