Joint seal WÜTOP^® Flex-Plus

Cut WÜTOP^® Flex-Plus to the required length using scissors. Roughly fit the material to the shape of the roof and pull the cover film off the adhesive coating on the back. Firmly press onto the tiles and smooth down into the trough. WÜTOP^® Flex-Plus can also be overlapped. Ensure that overlapping sections are adhered and pressed down very carefully, especially in corner areas. We recommend using a rubberised pressure roller for pressing down the product. If WÜTOP^® Flex-Plus is run up onto building components (e.g. chimneys), the upper edge must be fitted with a conventional cap strip and sealed with a permanently elastic sealant.

To ensure good, lasting adhesion, note the following:

• Only use in temperatures from +5°C


• The substrate must be clean and dry and free of dust and grease


• WÜTOP^® Flex-Plus must be accurately adjusted to the contour of the substrate and pressed down firmly


• Conduct your own adhesion tests on tiles with silicone coatings