M14 segmented construction site diamond cutting disc
Diamond cutting disc construction M14, segmented
CUTDISC-DIA-CONSTRUCTION-M14-D125MM
Register now and access more than 125,000 products
Highly economical
The construction site disc presents an optimum balance of function and cost-effectiveness. A segment height of 10 mm ensures a good service life.
Improved cutting characteristics
The fan segments provide better dissipation of heat and removal of dust in comparison with conventional segments.
M14 direct mounting
- Direct screwing onto the machine spindle
- Allows flush cutting
- Diamond cutting discs become dull at excessively high speeds and wear too rapidly at insufficient circumferential speeds
- If the ease of cutting decreases (indicated by heavy sparking), resharpen the disc in abrasive material, e.g. sandstone, with several cuts
- Separate larger workpiece cross-sections in several sections (swing cut)
- Work without pressure — the weight of the machine is sufficient. Increased pressure causes increased wear.
- Diamond cutting discs are designed for straight cutting. Cutting curves deforms the blade and results in core cracks and segment tear-offs — risk of injury!
- Although the tool is safe, always wear safety goggles and clothing while working
- Observe the information on the label (max. speed), restrictions of use and safety instructions
- The direction arrow on the disc must match the machine's direction of rotation
- Must not be used for lateral grinding
- Use the appropriate protective hood
- Clamping must be performed only by a trained specialist (do not use force, use clean clamping flanges of the same size, perform a test run)
- If grinding tools are clamped or used incorrectly or are damaged, they represent a danger and may cause serious injury
Datasheets(X)
- Particularly suitable for old concrete, concrete, exposed aggregate concrete, lightly reinforced concrete, Poroton, clay bricks, concrete pipes, interlocking paving stones, soft clinker brick, abrasive concrete, sand-lime brick
- For dry and wet cutting
Versatility (points system) | 3 of 4 points |
Service life (points system) | 2 of 4 points |
Cutting speed (point system) | 3 of 4 points |
Cut quality (point system) | 2 of 4 points |
Diameter (Ø) | 125 mm |
Drill hole | 14 mm |
Segment height | 10 mm |
Segment thickness | 2.2 mm |
Number of segments | 10 PCS |
Segment connection | Laser |
Max. rotation speed | 12250 rpm |
Max. circumferential speed | 80 m/s |
Last viewed
Work trousers
Heavy Duty non-slip floor marking adhesive tape
Stretch X shorts
Straight cutting ring fitting ISO 8434-1, zinc-nickel-plated steel
1-ear clamp with insert ring
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 10.9, plain
Grooved taper-pin ISO 8744 steel plain
Screw with flattened half round head and hexagon socket ISO 7380-1 A2-070 stainless steel, plain
Slotted set screw with truncated cone DIN 551, steel 14H, zinc-plated blue passivated (A2K)
Straight bulkhead fitting ISO 8434-1, zinc-nickel-plated steel