Manual drive-in stamp For system connector
Manual drive-in punch for system connector
MANDRIVINPNCH-F.SYSCON
Register now and access more than 125,000 products
- To efficiently mount system connectors that have been pre-drilled with CNC or VBL-2
- Flat mounting surface for connectors
- The fitting and drill hole are not damaged
- Wide mount for positioning on the edge of the material
- Joints are mounted according to the angle. With single-pins, the mount can be lowered
- For system connectors: SV 30, SV 20 E
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
Material | Steel / plastic |
Surface | 0 - not applicable |
Last viewed
Swivel joint For pneumatic tools
O-ring, imperial NBR 70
Shim ring DIN 988, steel, plain
Raised contersunk head tapping screw, C shape with PH recessed head DIN 7983, A4 stainless steel, plain. With cross recess.
Brake calliper file Wide
Screw handle spatula
Rubber module, large
Bricklayers' trowel, forged Suitable even for the most demanding tasks, since handle and blade are forged from one piece
Thread cutter NES 3 For male thread 35-152 mm and 1 3/8-6 inch
Zinc clip-on wheel weight For car aluminium rims