Mould release agent For thermoplastics and thermosetting plastics

Name: Mould release agent For thermoplastics and thermosetting plastics
Brand: Würth
SKU: 089050

Mould release agent
MOULDRLSEAGNT-SILICONEFREE-400ML

Art.-no. 089050

EAN 4011231893527

All versions

Prices for customers after login

Mould release agent For thermoplastics and thermosetting plastics

Art.-no. 089050

Prices for customers after login

Quantity

Exclusively for trade customers

Login/Register
Call customer service:

Can be used up to +120°C

Greatly reduces rejects

Physiologically safe

Washes off easily

Subsequent treatment of injection moulded parts such as printing, painting and metallising etc. is possible

Slight deformation of injection-moulded part

Silicone-free

Notice

Store the product in a dry place at a room temperature of 20° C. Shelf life of 24 months.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue

Datasheets(X)

Safety data sheet

Certificates/ Documents

Application area

For thermoplastics and thermosetting plastics

Instructions

Briefly and evenly spray the open metal moulds. As the solvents evaporate quickly, the injection moulding machines can be started immediately after spraying. Even narrow openings are sufficient for the fine spray jet to reach all parts of metal moulds.

Caution: Do not apply to hot surfaces (T ≥ 50° C)!

Contents	400 ml
Colour	Colourless
Smell/fragrance	Characteristic
Chemical basis	Mineral oil
Shelf life from production	24 Month
Conditions to maintain shelf life from production	dry storage area, 20°C
Silicone-free	Yes
VOC concentration (CH)	93 %
AOX-free	Yes
Max. temperature conditions	120 °C
Density	0.568 g/cm³
Density conditions	at 20°C

Suitable glove:

Product

Description

Nitrile chemical protective glove With cotton velour finish inside

Description:

Permeation level: 6

Nitrile chemical protective glove Long, heavy-duty design

Description:

Permeation level: 6

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time

Permeation level

< 10 min

≥ 10 min

≥ 30 min

≥ 60 min

≥ 120 min

≥ 240 min

≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.