Nail HN 101 For use in steel and concrete substrates
Nail HN 101
NL-HN101-72MM
Register now and access more than 125,000 products
Nails with shaft lengths of 72, 90 and 100 mm must be pre-tapped into place with a hammer. Please observe the corresponding device category when selecting your fasteners
Length calculation for nails used on concrete surfaces:
Penetration depth (min. 25 mm/max. 40 mm) + thickness of component to be fastened = nail or shaft length
Length calculation for nails used on steel surfaces (min. 5 mm thick):
Penetration depth (min. 8 mm/max. 12 mm) + thickness of component to be fastened = nail or shaft length
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
High-quality nail for steel substructures and concrete substrates (normal weight concrete ≥ C 12/15 ≤ C 50/60) in accordance with DIN EN 206
 | |
Material | Steel |
Surface | Zinc plated |
Design | Smooth |
Head type | Step head |
Shaft length (SL) | 72 mm |
Length (L) | 72 mm |
Shank diameter (Øds) | 3.7 mm |
Head diameter (Ø dk) | 8 mm |
Suitable for device type | Würth BST 350, Hilti DX 2, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
L-shaped four-way T-distributor
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain
Hexagonal bolt
Low-cut safety shoes, S2
Composite profile Flex-Roll 38/38 For the perfect edge in dry walling
Hexagonal bolt with thread up to head for pressure container construction ISO 4017, steel 5.6, plain
Cylindrical grooved pin with chamfer DIN 1473, A1 stainless steel, plain
Screw plug W.TEC® COVER CAP WP 700 For pipe thread
Safety boots S2 Uvex1 G2 6845
Single angle milling cutter HSS DIN 842A type H