Nail HN 101 For use in steel and concrete substrates
Nail HN 101
NL-HN101-90MM
Register now and access more than 125,000 products
Nails with shaft lengths of 72, 90 and 100 mm must be pre-tapped into place with a hammer. Please observe the corresponding device category when selecting your fasteners
Length calculation for nails used on concrete surfaces:
Penetration depth (min. 25 mm/max. 40 mm) + thickness of component to be fastened = nail or shaft length
Length calculation for nails used on steel surfaces (min. 5 mm thick):
Penetration depth (min. 8 mm/max. 12 mm) + thickness of component to be fastened = nail or shaft length
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
High-quality nail for steel substructures and concrete substrates (normal weight concrete ≥ C 12/15 ≤ C 50/60) in accordance with DIN EN 206
 | |
Material | Steel |
Surface | Zinc plated |
Design | Smooth |
Head type | Step head |
Shaft length (SL) | 90 mm |
Length (L) | 90 mm |
Shank diameter (Øds) | 3.7 mm |
Head diameter (Ø dk) | 8 mm |
Suitable for device type | Würth BST 350, Hilti DX 2, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Clamping pin/clamping sleeve ISO 13337 spring steel plain
Hex head screw with shank ISO 4014, steel 8.8, zinc-plated, blue passivated (A2K)
Hexagon Socket Head Cap Screw with low Head DIN 7984, steel 8.8, plain
FLEXEN® rock wool
Ducting clamp DIN3015-1, lightweight series, ribbed inner surface, W.TEC series
Hex head screw with thread up to head ISO 4017, A2-70 stainless steel, plain
Comfort assembly glove
Built-in socket EST-2
Hexagonal bolt with shank
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain