Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X55X60MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
 | |
Suitable for door handle | DH A 502 FS |
Material | Steel |
Surface | Zinc plated |
Length 2 (L1) | 55 mm |
Length 3 (L2) | 60 mm |
Length (L) | 115 mm |
Square size | 9 mm |
DIN direction | DIN R/L |
Standards | DIN 18273 |
Last viewed
Cross handle with insert nut
Low-cut safety shoes S1P type 2 Elten William blue Low ESD 727310
Castellated nut, low profile DIN 979, steel 05, plain
S3 high-cut safety boot Base B0177
ASSY® 4 JH joist hanger screw Steel zinc plated full thread pan head
Hexagon Socket Head Cap Screw
45° angled tube cable lug Standard (similar to DIN)
Flat washer with chamfer for high-strength fittings
Hand cartridge gun high-quality
Mid-stopper For redoslide M45-HV