Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X55X70MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
 | |
Suitable for fitting | 0 - not applicable |
Suitable for door handle | DH A 610 FS, DH A 802 FS, DH A 803 FS, DH A 807 FS, DH A 810 FS, DH A 811 FS |
Material | Steel |
Surface | Zinc plated |
Length 2 (L1) | 55 mm |
Length 3 (L2) | 70 mm |
Length (L) | 125 nm |
Square size | 9 mm |
DIN direction | DIN R/L |
Standards | DIN 18273 |
Last viewed
Machine screw tap, through hole Ruko MF DIN 374 HSCo shape B
AL 11 long plate pair
Open-end plug-in torque wrench head drive Stahlwille 731a/40
ASSY® 4 A2 BP slate screw A2 stainless steel plain full thread back panel head
Professional boltless rack
Hexagonal bolt with thread up to the head DIN 933, A2 stainless steel, plain
Professional shelves
1/4-inch angled extension
Countersunk head screw with recessed head, H DIN 965, steel 4.8, plain
Work vest