Panic pin, split, 9 mm with drill hole at front and longitudinal groove
Panic pin with front-end bore
PANCPIN-F.DRFRN-ST-(ZN)-9X60X65MM
Register now and access more than 125,000 products
- The panic pins are split and used to connect two door handles on a panic door
- This connection element moves the safety catch
- Due to different door thicknesses and penetration depths in the door handles, these spindles are required in different lengths
- For locks with split bolt
Observe the lock position when selecting the pin lengths. Please note that the fastening screws for the fittings must also be changed when using shorter or longer panic pins. The pins are marked according to fire protection standards.
Specified dimensions not binding. Subject to technical changes!
Datasheets(X)
A grub screw with pin is used for fixing in place. This involves the pin cutting into the pin groove.
 | |
Suitable for door handle | DH A 502 FS |
Material | Steel |
Surface | Zinc plated |
Length 2 (L1) | 60 mm |
Length 3 (L2) | 65 mm |
Length (L) | 125 mm |
Square size | 9 mm |
DIN direction | DIN R/L |
Standards | DIN 18273 |
Last viewed
Conical countersink HSS Ruko ULTIMATECUT DIN 335 plain
Identification rings, PVC
CLIP-O-FLEX® holder Sprayflex
Hard hat uvex pheos B S WR
Safety knife Martor SECUNORM 525 525001
Clamping pin/clamping sleeve, slotted, heavy-duty design ISO 8752 A2 stainless steel
Insect remover
Connecting technology
Laser range finder WDM 6-22
Sealing lid