Sanding disc, fleece Klingspor MFW 600
Non-woven abrasive disc Klingspor MFW 600
FLCORBSANDR-KLINGSPOR-337944-D150-CRS
Register now and access more than 125,000 products
This is the specialist for welding seam machining on stainless steel. The four different degrees of fineness cover the entire range of machining operations, from adjusting the grinding finish through to the finish cut. The abrasive grain made from silicon carbide is bonded to the polyamide fibre fleece with synthetic resin.
Datasheets(X)
This high-performance fleece disc is intended for use on a fillet weld sander. The best results are achieved in the mid speed range, i.e. at 5000-7500 rpm. Especially when machining stainless steel e.g. in container or tank construction, this tool is used for finishing as well as for eliminating small defects on the surface. It is also often used for matting or burnishing.
Diameter (Ø) | 150 mm |
Drill hole | 25.4 mm |
Design | Coarse |
Colour | Red |
Suitable for | Fillet weld grinder, Angle grinder |
Last viewed
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 10.9, plain
Wall mount
Pan head screw with H cross recess DIN 7985, A2 stainless steel, plain
Face shield, accessories
Work jacket
Threaded fitting, stainless steel, with ball joint
Storage compartment For square holes in perforated plates, workshop trolleys and the ORSY®1 shelving systems
Threaded rod with trapezoidal thread WN 976 with trapezoidal thread in accordance with DIN 103
System wing door cabinet 12.8 805x770 mm
Spring cotter pin