Satin-finish wheel brush Crimped stainless steel with hole
Stainless steel brush
BRSH-SST-SATNFINR-100X70X19MM
Register now and access more than 125,000 products
- Increased stability during brushing
- Crimped wire bristles support each other
- Uniform and consistent machining results due to uniform bristle arrangement
- For use on angle grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Can be used on all standard stationary drive machines and bench grinders thanks to variable bore diameters.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
Deburring, cleaning and removal of oxide layers and paints
Diameter x width x drill hole | 100 x 70 x 19 mm |
Max. rotation speed | 8000 rpm |
Material of wire | Stainless steel |
Design | Corrugated |
Wire diameter | 0.2 mm |
Suitable for satin finisher (point system) | 4 of 4 points |
Aggressiveness | Middle |
EN standard | 1083-2 |
Last viewed
Stirrup handle on outer plate
HSCo8 end mill, short, centre-cutting DIN 844K
Flat blade fuse ATO Silver
Slotted raised countersunk head screw DIN 964, steel 4.8, plain
Ash handle
3M Cubitron II flap disc
Retaining pin For square holes in perforated plates, workshop trolleys and the ORSY®1 shelving systems
GEFU® thread-rolling screw With Taptite 2000® thread, hexagon head with collar
Small abrasives mini fleece disc
Feather key, high profile DIN 6885, steel C 45 K, plain, shape A