Separator
Separator tool
SEPRTL-SPNW115MM
Register now and access more than 125,000 products
- This separator is used if puller hooks cannot reliably grip the part being extracted as it is seated too closely. The separating blades are mounted between the parts and pressed against each other. The wedge shape of the separating blade separates the assembly.
- The separator can also be used to remove thin parts, as the pull-off force acts on a large area. Prevents undesirable deformations and damage. The separating blades are mounted with the flat surface under the part to be removed.
- Drop-forged and hardened separating blades
- High-strength clamping screws
Datasheets(X)
 | |
Min./max. internal clamping width (A) | 22-115 mm |
Width of clamping jaw (B) | 170 mm |
Spindle length (C) | 250 mm |
Min./max. hole distance (E) | 115-208 mm |
Material of separating blade | Vanadium steel |
Surface of the separating blade | Zinc plated |
Thread dimension | M14 x 1.5 |
Last viewed
Tapered pin, unhardened DIN 1, plain steel, unhardened, design A (ground)
Slotted flat-head screw ISO 1580, A4 stainless steel, plain
90° elbow, reduced with female and male thread EN10242 A4, reduced, hot-dip galvanised malleable iron
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
Winter jacket Fristads Airtech 4058
System connector SV 20 E, twin-pin
Jacket Planam Highline
Circlip for bore hole, standard version, shape J DIN 472 for bore holes, spring steel, phosphated and oiled
Varioprimer safe + easy
Protective glove winter Ejendals Tegera 595