Solid carbide drill cutter Multi Performance pneumatic
SC drill cutter Multi Performance pneumatic
CTR-SPTWELD-SC-MULTI-PERFORMANCE-9X44MM
ZEBRA
Register now and access more than 125,000 products
Enables reliable loosening of ultra high-strength spot weld connections
Innovative rake with a perfect balance between sharp cutting edges and high stability
Enables precise cutting even with rough spot welds or curved material
Innovative face geometry, perfectly combining the benefits of a drill bit and milling cutter
Very good tapping behaviour
Centring point with two cutting edges above centre
Little effort required
Sharp cutting edge design
Low-vibration running
Four cutting edges with extremely unequal pitch
Extremely durable and robust
Significantly longer service life compared to conventional solid carbide spot weld cutters
AlTiN multi-layer wear protection coating
- Extremely high temperature resistance up to 950 °C
- Very hard and wear-resistant (hardness approx. 3,300 HV)
- Reduced heat input in the bodywork panel (curing, melting of the adhesive or tempering colours are avoided)
- Multi-layer structure for optimal chip removal and improved cutting properties (prevents material becoming welded)
Product packaging made of 100 % PCR (recycled plastic from household waste), 100 % recyclable and Cradle to Cradle Certified® Bronze
- For use in pneumatic machines (e.g. Vario Drill, Spitznagel etc.)
- The 9 mm tool diameter ensures reliable drilling of the weld spot and of its heat input area (advantage over an 8 mm diameter). Moreover, the hole created is not so large that excessive filling is required when reinstalling bodywork parts (advantage over a 10 mm diameter)
Datasheets(X)
For drilling any type of material connection:
- Cutting spot weld connections
- Trimming rivet connections
- Cutting individual layers
- Trimming friction welding elements
- Trimming flow-hole screws
- Solid carbide is extremely hard, making it very brittle and prone to breaking if not handled correctly
- Step 1: Remove the protective cap. Clamp the drill cutter. Check the concentricity.
- Step 2: Place the drill cutter in the position of the spot weld and let it run at full rotation speed
- Step 3: Fully immerse in the spot weld at full rotation speed
- Avoid hard contact with the material to be drilled, impacts or dropping the drill cutter under all circumstances
- The use of coolant/lubricant is not necessary
Last viewed
High-visibility work dungarees
Low-cut safety shoes S3 Elten Shadow Low ESD 721081
Outer corner For LFK cable routing conduit
SC short twist drill bit DIN 6539
Hexagon weld nuts DIN 929, steel, plain
Heat-resistant crepe masking tape +120 °C
Abrasive fleece sheet VSM KV301
Polo shirt
GPN 210 grip cap Ethylene vinyl acetate (EVA), free from plasticisers, yellow
Work jacket Kübler Image Dress 1345 3411