Special system screw For push-in connector
Special screw steel zinc plated yellow cs head TX
SPECSCR-CS-WO-XL/XXL-TX40-8X180/167
Register now and access more than 125,000 products
Depending on the connector type, the appropriate type of special system screws should be used as per ETA-12/0067 approval in order to guarantee the specified characteristic load-bearing values.
The specified characteristic load-bearing values are guaranteed by using the appropriate system screws with the respective connector in accordance with ETA-12/0067.
- The special system screws fit perfectly into the screw hole of the respective connector
- Half-tip ensures optimum initial screw bite and reduced risk of splitting through its pre-drilling effect
- Reinforced screw head
To be used for connectors
Datasheets (0)
Certificates/ Documents (0)
Last viewed
Three prong knob with insert nut Hollow hub
Twist drill bit, metal Ruko DIN 338 type VA HSCo8 plain
Cetus trousers with holster pockets
Full face mask
Pipe cable lug with inspection hole
EPS profile double cylinder
REDOSLIDE Z100-H/Z100-HW interior sliding door fitting For ceiling and wall mounting for wooden doors
Metric ratchet combination wrench with POWERDRIV®
Thin-walled heat-shrink hose Without internal adhesive
Fitting Brass, 16003
