Special system screw For push-in connector
Special screw steel zinc plated yellow cs head TX
SPECSCR-F.WOCON-CS-M-TX25-6,5X65/50
Register now and access more than 125,000 products
Depending on the connector type, the appropriate type of special system screws should be used as per ETA-12/0067 approval in order to guarantee the specified characteristic load-bearing values.
The specified characteristic load-bearing values are guaranteed by using the appropriate system screws with the respective connector in accordance with ETA-12/0067.
- The special system screws fit perfectly into the screw hole of the respective connector
- Half-tip ensures optimum initial screw bite and reduced risk of splitting through its pre-drilling effect
- Reinforced screw head
Datasheets(X)
To be used for connectors
 | |
Type description | M |
Nominal diameter | 6.5 mm |
Length | 65 mm |
Head type | Countersunk head |
Head diameter | 10 mm |
Head height | 3 mm |
Internal drive | TX25 |
Thread design | Full thread |
Thread length | 50 mm |
Core diameter | 3.25 mm |
Material | Steel |
Surface | Zinc plated yellow |
Product weight (per item) | 7.715 g |
Last viewed
Crimping jaws For crimping tool B12
Round head screw with square neck DIN 603, steel 4.8, zinc-plated, blue passivated (A2K)
Sport Plus S3 FLEXITEC® safety shoes
Safety sandals S1P Elten Scott XXT ESD 719731
Safety sandals, S1
Safety screw with hexalobular head and pin Similar to ISO 10642 because of TX drive, A2 stainless steel, plain
Fixanchor internal thread W-FAZ-IG/S - push-through installation
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
EPS profile double cylinder
Grooved taper-pin ISO 8744 A1 stainless steel plain