Straight connection piece For hard-to-reach lubrication and manifold points
Connection piece straight
FITT-CLS-CONPIECE-M8X1TAP-M8X1-18MM
Register now and access more than 125,000 products
On central low-viscosity grease lubrication units:
Lines with a diameter of 4 mm are connected to connection pieces with tapered rings and union bolts M8x1.
On central grease lubrication units:
Lines with a diameter of 6 mm are connected to connection pieces with double-tapered rings and union bolts M10x1.
Datasheets(X)
For extension if the lubrication or support point is recessed.
 | |
Connection thread (d2) | M8 x 1 |
Outlet thread (d) | M8 x 1 tapered |
Width across flats (SW) | 11 mm |
Length (L) | 18 mm |
Material | Steel |
Surface | Zinc plated |
Last viewed
Clamping pin/clamping sleeve, slotted, heavy-duty design ISO 8752 A2 stainless steel
Tension anchor V plus
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
Colour pin nail colour
Clamping block For interior door push-in spigot hinges
Composite plain bush with flange
Timing tool set 7 pieces, for Chrysler-Jeep 2.5-2.8, diesel (R25-R28)
Cover panel, plastic-coated For cabinet covers of system cabinets
Universal holder E 6.3 (1/4") With stainless steel sleeve, snap ring and permanent magnet
Work vest