Stud screw
A2 70 stainless steel with external hexagon
STUDSCR-WS9-A2/70-M12X350
Register now and access more than 125,000 products
A2-70 stainless steel
In order to achieve additional protection against moisture, the stud screws must always be mounted on the protrusions of the corrugated profile sheets. The mounting of the stud screws should always take place in perpendicular alignment to the roof slope.
The load application point must be no more than 40 mm above the upper edge of the protrusion/upper flange.
Datasheets(X)
We recommend the following procedure for mounting the stud screws:
- M10 stud screws: pre-drill Ø 13 mm hole in roof skin and Ø 7 mm hole in wood
- M12 stud screws: pre-drill Ø 14-mm hole in roof skin and Ø 8.5-mm hole in wood
 | |
Thread type x nominal diameter x length (d) | M12 x 350 mm |
Material | Stainless steel A2 |
Property class | 70 |
Surface | Plain |
Width across flats (SW) | 9 mm |
Thread length (thread for woodwork) | 130 mm |
Thread length (metric thread) | 180 mm |
Last viewed
Stretch X ladies' trousers
Low-cut safety shoes, S2
Steel spacer stud
Reducing nipple
Shim ring DIN 988, steel, plain
Paint retouching pen
Disc spring for ball bearing
Flat square For FB windowsill duct
Profile half cylinder EPS
Hexagon socket screw-in nut with collar DIN 908, A4 stainless steel, plain