Universal adapter For cooling system tester
Univ. adap., cool. sy. test. 19.5-38 mm
UNIADAPT-F.CLSYSTEST-085350-SML
Register now and access more than 125,000 products
Datasheets(X)
Particularly for Japanese vehicles
1. Adapter rubber and opening to be sealed must be free of oil, grease and glycol residues
2. Press the adapter into the radiator opening or expansion tank and seal by rotating the two adjustment wheels against one another
3. Connect radiator tester
4. Pump approx. 1.3 bar into the cooling system using the hand pump
5. The pressure in the cooling circuit must not drop by more than 0.2 bar within 10 minutes.
6. In the event of a drop in pressure, localise and eliminate potential points of leakage (e.g. water pump, hoses, cylinder head seal)
Caution: The universal adapter should never be immersed in cooling fluid as this causes fluid leakage at the valve when the pressure is released.
null | null |
Last viewed
Blanking plug for rubber module
Flat head tapping screw, type C with hexagon socket
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
Dome head solid rivet, inch, aerospace MS 20470, aluminium
3/8 inch extension
Holding magnet For hand-held lamps
Engine oil TRIATHLON® Formula DX2 5W-30
Marking pin
Acrylic fire-retardant joint sealant
Half-shell hexagon crimping insert