Universal adapter For cooling system tester
Univ. adap., cool. sy. test. 19.5-38 mm
UNIADAPT-F.CLSYSTEST-085350-SML
Register now and access more than 125,000 products
Datasheets(X)
Particularly for Japanese vehicles
1. Adapter rubber and opening to be sealed must be free of oil, grease and glycol residues
2. Press the adapter into the radiator opening or expansion tank and seal by rotating the two adjustment wheels against one another
3. Connect radiator tester
4. Pump approx. 1.3 bar into the cooling system using the hand pump
5. The pressure in the cooling circuit must not drop by more than 0.2 bar within 10 minutes.
6. In the event of a drop in pressure, localise and eliminate potential points of leakage (e.g. water pump, hoses, cylinder head seal)
Caution: The universal adapter should never be immersed in cooling fluid as this causes fluid leakage at the valve when the pressure is released.
null | null |
Last viewed
Random orbital sander ETS 150-5.0-E POWER
ASSY® 4 BP rear panel screw Steel zinc plated full thread back panel head
Backing pad sanding disc ZVL VSM
Classic base plate For number plate holders
GEFU® thread-rolling screw With Taptite 2000® thread, flat head and hexalobular drive
Brake calliper impact wrench, 3/4-inch FOR COMMERCIAL VEHICLES, MAN TGA/TGS/TGX
DUO wire end ferrule With plastic sleeve
Sponge float With hydro sponge
Hexagon nut DIN EN 14399-4, steel 10Z, hot-dip galvanised, for high-strength structural bolting assemblies
Drawer divider set, BASIC KWB, 6 pieces