VLB 40 door hinge, 3D design
VLB 40 3D Design door hinge
RECESHNGE-VLB40-3D-DESIGN-HNG-(A2-OPTIC)
Register now and access more than 125,000 products
- The hinges are cut into the block/blind frame/wooden wrap-around frame/steel frame and the door and are not visible when the door is closed
- Can be adjusted in three directions without removing the door leaf
- The toothed clamping plates reliably prevent unwanted height adjustment
- The hinge screws are covered by magnetic cover panels
- Maintenance-free
To install the hinges, milling jigs, a milling cutter with ∅ 24 mm (not in product range) and a stop ring with ∅ 30 mm (not in product range) are required.
If the hinges are installed on wooden wrap-around frames, separate mounting plates are required.
Specified dimensions not binding. Subject to technical changes.
Datasheets(X)
Suitable for flush-closing interior, WC/bathroom and apartment entrance doors on wooden block, wooden wrap-around, steel and aluminium frames.
 | |
Suitable for | Flush wooden doors |
Material of housing | ALU/ST |
Material of cover | Stainless steel |
Colour | Stainless steel coloured |
Surface | Lacquered |
DIN direction | DIN R/L |
Lateral adjustment | +/- 3 mm |
Height adjustment | +/- 3 mm |
Contact pressure adjustment | + 2 mm |
Integrated hinge side security | No |
Load capacity with 2 hinges | 60 kg |
Opening angle | 180 Degree |
EC declaration of conformity (CE) | No |
Environmental Product Declaration | No |
Included in delivery | 2 x VLB 40 3-D hinges, 8 x special screws M5 x 13.5 mm, nickel-plated, TX20 (for mounting hinges on the mounting plate for wooden wrap-around frames) |
| Milling ratios | |||
| Milling, frame (X) | Milling, leaf (Y) | Distance (Z) | Radius (R) |
| 3 mm | 3 mm | 0 mm | 0 mm |
| 4 mm | 4 mm | 0 mm | 0 mm |
| 4 mm | 5 mm | 1 mm | 1 mm |
| 5 mm | 4 mm | 1 mm | 1 mm |
| 5 mm | 5 mm | 0 mm | 2 mm |
| In general, it should be noted that the milling ratios in the table become less favourable towards the bottom and restrict the adjustability of the hinge. | |||
| Ideal case: Leaf milling 3 mm, frame milling also 3 mm. A large radius at the leaf and frame is recommended | |||
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Work hoodie sweater
Work jacket
Cable feed coil push rod set
Work dungarees
Connecting plate For connecting roof assembly ladders
Spiral clamping pin, heavy-duty design ISO 8748 steel plain
Hexagonal bolt with flange DIN 6921, A2-70 stainless steel, plain
Flush switch, round
Silicone remover
Work shirt