W-VIZ-AV DYNAMIC anchor rod, zinc-plated steel

Name: W-VIZ-AV DYNAMIC anchor rod, zinc-plated steel
Brand: Würth
SKU: 0905481612

Anchor rod W-VIZ-AV/S dynamic zinc-plated steel
ANC-(W-VIZ-AV/S DYN)-(A2K)-50-M16X220

Art.-no. 0905481612

EAN 4062856619467

All versions

Specification

For W-VIZ/S dynamic injection system (pre-positioned and in-place installation, concrete, fatigue loading)

Required chemical injection mortar: Concrete specialist WIT-VIZ, WIT-VIZ Express

Anchor rod for injection system W-VIZ-AV/S dynamic. Individual fixing point: Fatigue-related action (dynamic), zinc-plated steel.

Cotter-pin and push-through installation

Mounting with low expansion pressure allows small spacing and edge distances

The geometry of the anchor rod allows safe follow-up expansion capability

Mechanical drill hole cleaning: Easy handling, very good drill hole cleaning, high working loads

Force-controlled/torque-controlled expansion anchor made of galvanised steel in sizes M12, M16, M20

Notice

W-VIZ/A4 dynamic stainless steel A4 and W-VIZ/HCR dynamic high-corrosion-resistant steel, available by special order. Suitable injectable mortar: WIT-VIZ, WIT-VIZ Express

European Technical Assessment ETA-18/0979: Retroactively installed fasteners in concrete under fatigue-relevant cyclic effect (dynamic response)

Application

Application area

Effect of action on anchorages: Fatigue loading (note: Static and quasi-static action according to ETA-04/0095).

Anchoring base:

Reinforced or non-reinforced normal weight concrete

Strength class C20/25 to C50/60

Cracked and uncracked concrete

Temperature range -40°C to 80°C, maximum short-term temperature +80°C and maximum long-term temperature +50°C

W-VIZ/S dynamic (zinc-plated steel) can be used in dry indoor areas.

Suitable for attaching slewing cranes, crane runways, guide rails in lift shafts, ventilation fans, machinery, welding robots, conveyors, street and motorway traffic signs, gantries, attachments in road and railway tunnels etc.

Instructions

Clean the drill hole: 2x blow-out, 2x mechanical brush-out, 2x blow-out. If the drill hole is M20 or larger, blow out with pneumatic air using the appropriate pneumatic air nozzles