Wallpaper stripper concentrate
Wallpaper stripper concentrate
WLPAPSOLVR-SOLVENTFREE-1L
Register now and access more than 125,000 products
- Strong removal properties and high penetration ability
- Apply with brush, sponge or a suitable spraying device
- Contains highly degradable surfactants
- Powerful, quick action
- Low consumption
- Solvent-free
Keep the container well sealed and store in cool place.
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. If our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and carry out further development.
Datasheets(X)
For quick and easy removal of wallpapers made of paper, textile, vinyl and ingrain. The extremely strong dissolving properties allow for fast and simple removal of even ingrain wallpapers with several layers of paint and other wallpapers that are similarly difficult to remove. Consumption: 250 ml are sufficient for approximately 35-50 m², depending on the dilution ratio.
Mix 250 ml of wallpaper stripper concentrate in 5 l of water. With light wallpapers, up to 10 l of water can be added. Dilute higher quantities in the corresponding ratio. Hot water increases the effectiveness.
Apply the solution liberally with a brush or a suitable spraying device (do not inhale the spray mist) and allow the product to react for approx. 15 minutes. If necessary, repeat the application. The soaked wallpapers are then easy to strip. Roughen waterproof and painted wallpapers using a needle roller or rough sandpaper prior to application.
Any stains can be easily removed with water. Any successive bondings will not be affected. Clean all equipment with water.
Chemical basis | Anionic tenside |
Colour | Yellow transparent |
Density | 1 g/cm³ |
pH value | 7 |
Solvent-free | Yes |
Contents | 1 l |
Container | Plastic bottle |
Shelf life from production | 24 Month |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Complete printed Classic number plate holder
Wheel hub puller set 8 pieces
Premium System hammer holder
Safety dolphin clamp, fully-insulated
Spray tube for fire protection foam 90
Special drill bit For plastic sleeves, dia. 14 mm
Blade holder, deburring tool Ruko 107054 rapid deburrer HSS blade
Connector, pneumatic
ASSY® 4 COMBI timber screw Steel zinc plated partial thread hexagon head
Half-shell pin crimping insert