Wing-tip drilling screw, countersunk milling head with pias AW drive®
Wing-pias C1 flake zinc silver countersunk head AW
SCR-DBIT-WNG-CS-CUTHD-AW30-(RSI)-6,3X50
ZEBRA PIAS
Register now and access more than 125,000 products
- Hardened C1 (not stainless steel!)
- RUSPERT® coated (silver)
- Countersunk milling head for use with hard and softwoods
- AW® drive for optimum power transmission and conservation of corrosion protection
Advantages in comparison to traditional drilling screws made of case-hardened steel
- For use with steel sub-structures with a strength of up to 700 N/mm2
- Faster cutting speeds possible
- The drill tip is strong enough for use with reinforced steel substructures
- The wing pias® of nominal dia. 6.3 mm, can be used in steel sub-structures made of A2 stainless steel up to 4 mm thick
- Wing-pias® screws must be appropriately tested for usability for each application case. Only install using application tools with a depth stop and claw coupling. *Wood thickness and surface thickness lu = max. attachment length lB
- Drilling screws must be processed with a suitable drill driver (e.g. cordless drill driver with depth stop)
- The use of impact screwdrivers is not permitted
- Drilling screws must be attached perpendicular to the surface of the component
Drilling screws may only be used where dampness is not to be expected. For fasteners with a construction permit, the permit, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
CAD data (available after login)
- 1. Force feeding of the screw is prevented by the wings drilling out the wood
- 2. The core hole is drilled into the substructure. The wings break off upon contact with the metal
- 3. The first few turns of the screw cut the thread, the remainder of the screw then screws into the thread
 | |
Nominal diameter (d) | 6.3 mm |
Length (l) | 50 mm |
Head diameter (dk) | 12.4 mm |
Head height (k1) | 4.5 mm |
Drill tip length (lp) | 12 mm |
Other standard | Company standard |
Material | Stainless steel, C1 |
Surface | Flake zinc silver |
Head type | Countersunk milling head |
Internal drive | AW30 |
Thread type | UNC |
Min. recommended substructure thickness | 2.0 mm |
Max. material thickness to be drilled through (metal) (lU) | 6 mm |
Max. attachment thickness (lB) | 24 mm |
Min./max. recommended installation speed (idling) | 1200-2500 rpm |
RoHS-compliant | Yes |
Last viewed
CEE plug 250 V/400 V, 6 H
Intermediate layer for ISO P clamping system
Hexagonal bolt with thread up to the head
HPC solid carbide drill Speeddrill 4.0-Universal, DIN 6537L, long 5xD, 4 drill heels, with internal cooling
Metal core drill bit Ruko HSS plain Weldon holder
Hard industrial swivel castor
HSCo Multi Special MF thread machine tap for through holes DIN 374
Low-cut safety shoes, S1P
Torque wrench For plug-in tools
Slotted flat-head screw DIN 85, steel 4.8, zinc-plated, blue passivated (A2K)